"Installed listed part, ran two rinse cycles to make sure it wasnt over filling, and cleaned coin catch, tested okay."

"Started a rinse and spin cycle, and it would just keep draining. Stop for a few secs, then start draining again. I took the top off and disconnected and reconnected pressure sensor, and cleared hose. As soon as i put it back in, it started filling, but over filled. Once it got a few inches past the top of door, I cancelled and drained. Leaving unit unplugged in the meantime to prevent flooding. Will need p#DC96-01703G; ordrd 1 DC96-01703G."

"Installed inlet valve, bled air, tested okay. Wasn't able to cycle ice maker, but if no ice by morning, will need to come back."

"Ice maker probably fine, just no water going to it, good pressure. Nothing leaving inlet valve, will need new inlet p#2188746, and water filter p#2203220 which owner will purchase, I'll install when we return; ordrd 1 2188746."

"Unit unplugged at time of service, and found water off as well, turned back on, and started a cycle. Unit filled and washed, tested okay. I did turn dual zone on so the upper spray arms could wash, will need to use as normal."