"Pulled evap panel, found large block of ice on top left of evap panel. Can't find the reason for this buildup other than maybe the door being left open. Unit defrsoting normally, and all fans working. Will need to use as normal."

"installed listed part, tested okay. ; used 1 W11395618 from stock"

"Installed capacitor, and as soon as machine is powered up, it locks and starts spinning. Able to put it into diagnostics, but shows no error codes, and will not do anything. When powered off and back on, it starts spinning again. Will need main relay board p# W11556725; ordrd 1 W11556725."

"Unit giving f3e1 error at time of service. (Wash spin done) flash with lid lock, then done flashes. f3e1 is not in the diagnostics, but for a different machine I see it's for a water pressure issue. Attempted many times to run service mode on unit, but only makes a loud humming noise while powering the motor. I tried hand spinning motor the 4th time, and it started to spin and put a splash of water in, locked the lid, then gave the same f3e1 error code thats not in diagnostics. Only way to take it out of this error mode is to unplug and replug machine. Diagnostics will not even start. Door did unlock on its own, also found oil leaking from motor capacitor. Will need to replace p#W11395618 before unit can be further tested, may be issues with motor and controller, but must replace this capacitor first.. total after; ordrd 1 W11395618."

"installed agm30045804 and 5301EL1001H, tested okay."