Needs knob. Owner going to replace it. P# WP33001621

Reset unit, ice maker harvested and filled. Use as normal.

Owner did update, had no affect. Will need main control p#WH22X38697 and inverter p#WH22X38837. Only other option would be to call GE for assistance. Ordrng 1 1 and 1 1. States that autho needed.

Stored codes: 3 for locked rotor 89, accelerator fault. 39 for vent damper. 18 for drain pump clearing. 26 for out of balance. 66 for inverter fault. Factory bulletin applies for models Sept 2019 to Feb 2021. States unit needs update via Smart HQ or SUM module P#WH98R4697903. Cleared fault codes

EI code is a fill error, and hot water was 90% off. Could be an issue with the valve. When I turned it a little, full pressure started. Tested hot and cold, both working normally now. Also ran a spin cycle, and it never reaches full speed. It starts to speed up, but vibrates heavily and clicks and slows down. This unit will never spin clothing properly. Tub out of round, and bearings are failing. Repair for this would be far greater than a new unit. Would need rotor, stator, bearings, and tubs. Reset unit. I did get it to full speed spin, but this won’t be reliable with any type of load in it