Installed listed parts, both ovens tested okay.

Upper front fuse failure. And will need rear limit p#WP4449751 before unit can be further tested. Upper oven did not come on after bypassing upper fuse, but lower unit did work. possible relay board will be necessary, but needs fuses first; ordrd 1 W11610133 and 1 WP4449751.

Unit is actually working as normal. Ran a rinse and spin cycle before I arrived, and was able to watch the spin cycle. Cloths come out as normal, impossible to extract any more water from these. Suspension isnt an issue either. After overfilling the tub, the suspension didnt even bottom out.

Unit needs lower spray arm p#WD22X27724 which is on backorder. And heating element p#WD05X30298 also upper plastic trim is broken p#WD34X26485 which is NLA. Its taped in place currently, but would need to be replaced to make it proper.

No stored codes, all manual tests passed, locks, agitation, and spin both tested okay. Bearings sound fine during high spin speed. Ran a calibration mode, owner will have to use as normal, and let us know how it does after this.